Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| troubleshooting [09/24/2024 08:29 (6 months ago)] – [Brandmeister Issues] admin | troubleshooting [10/22/2024 08:04 (5 months ago)] (current) – [OpenSpot 4 Pro] admin | ||
|---|---|---|---|
| Line 32: | Line 32: | ||
| \\ | \\ | ||
| //User Note:// | //User Note:// | ||
| - | Picked up a new B1+ at Ham Radio Outlet, and the unit works with the OpenSpot 4 Pro (hears announcements, | + | Picked up a new B1+ at Ham Radio Outlet, and the unit works with the OpenSpot 4 Pro (hears announcements, |
| + | |||
| + | ===== P7 Discharging ===== | ||
| + | Q: "My P7 will all of a sudden starts discharging even though it is plugged in while monitoring, I am using the supplied cable and charging block. I will have to unplug and restart in order for it to charge again. Has anyone experienced this and if you did, was there a simple fix?" | ||
| + | A: "Yes, mine too, Joe. I have actually been charging it on the right side USB-C and it charges to 100% ok, and stays there. When I plugged into left side I don't remember, but it ended up 0 overnight. Had to unplug once right side and plug back in to start charging." | ||
| ===== Rebooting Continuously ===== | ===== Rebooting Continuously ===== | ||
| Line 56: | Line 60: | ||
| Q: "I have a B1+ that is still working fine. However, the last time I turned it on I notice the volume on BMR Brandmeister was quiet. I had the volume on full but it was way too quiet to listen in the car for example. Has anyone else noticed this? | Q: "I have a B1+ that is still working fine. However, the last time I turned it on I notice the volume on BMR Brandmeister was quiet. I had the volume on full but it was way too quiet to listen in the car for example. Has anyone else noticed this? | ||
| A: "Turn the volume down to 3 and reboot. 3 is the default setting. Mine works fine on my B1c and B1+. My normal setting is 5." Source: Bob Vincent\\ | A: "Turn the volume down to 3 and reboot. 3 is the default setting. Mine works fine on my B1c and B1+. My normal setting is 5." Source: Bob Vincent\\ | ||
| + | \\ | ||
| + | Q: "I have the B1 + with the Bluetooth dongle and Bluetooth mic and Bluetooth ear loop. With no other way but using the radio speaker only and turned up to 16. I can barely hear any sound. I have the dongles off and unplugged. Can anyone tell me why my audio is so low?" | ||
| + | A: "It is NOT the dongle or Bluetooth equipment. Bob is correct. The trick is to ALWAYS turn you volume down to 3 when you turn off the radio or reboot." | ||